Thu Jan 14, 2016 4:56 pm
#95756
Hi, I am trying to figure out which is the best bit to use with my router to clean up the shaved areas so I have one even consistent surface for the light to come through. I used a ball sphere bit to shave out the areas.
![Image](http://i8.photobucket.com/albums/a4/Slayers94rx7/2015-11-26%2013.44.19_zpsyyhffd3m.jpg)
This is how it looked initially. As you can see, the light is not consistent in the shaved areas. That is what I want to fix.
![Image](http://i8.photobucket.com/albums/a4/Slayers94rx7/2015-11-26%2013.55.48_zps1vfafrrf.jpg)
I used another ball sphere bit that was a little bigger, but still not even.
![Image](http://i8.photobucket.com/albums/a4/Slayers94rx7/2016-01-11%2017.14.02_zpsiejcrlns.jpg)
Any recommendations will be appreciated.
Thanks,
Eric
![Image](http://i8.photobucket.com/albums/a4/Slayers94rx7/2015-11-26%2013.44.19_zpsyyhffd3m.jpg)
This is how it looked initially. As you can see, the light is not consistent in the shaved areas. That is what I want to fix.
![Image](http://i8.photobucket.com/albums/a4/Slayers94rx7/2015-11-26%2013.55.48_zps1vfafrrf.jpg)
I used another ball sphere bit that was a little bigger, but still not even.
![Image](http://i8.photobucket.com/albums/a4/Slayers94rx7/2016-01-11%2017.14.02_zpsiejcrlns.jpg)
Any recommendations will be appreciated.
Thanks,
Eric