Tue Jul 29, 2014 10:50 am
#85934
Yea Be careful with those Harbor Freight bits, they don't have many flutes cut in,
And if you go in as deep where the the shaft of the bit is in the foam, Your now Tearing through the foam, instead of cutting it.
BTW: Bits Break, Especially the 1/32" bits - after you buy the dremel set, You'll be looking on-line just for the 1/32"s
33 cents each Here
http://www.wttool.com/index/page/produc ... s+%28WT%29
And if you go in as deep where the the shaft of the bit is in the foam, Your now Tearing through the foam, instead of cutting it.
BTW: Bits Break, Especially the 1/32" bits - after you buy the dremel set, You'll be looking on-line just for the 1/32"s
33 cents each Here
http://www.wttool.com/index/page/produc ... s+%28WT%29
I got one foot in the grave the other on a banana peel !
The Pumpkin Carving Group - Facebook Group
The Pumpkin Carving Group - Facebook Group